|Customer Assembly Instructions.
1. Insert the threaded end of the Hook through the hole in the mirror shell and Pre-thread
the knob at least three (3) turns onto the hook. (A)
2. Be sure that the shaft of the nut is completely in the hole of the mirror shell to keep the
shell tight to front of mirror. (B)
3. Slip the hooked end (D) over your vehicles mirror edge (C) and then tighten down the
Peal backing from felt pad half way off.
Place "tacky" side on hook.
After you have the pad on the hook remove the remainder of the strip and secure the pad all
the way on the hook.